1. Equipment features:
1) Conveyor belt transplanting operation is simple, easy to master, easy to maintain;
2) No need to set parameters, compatible with multi-size parts and receiving;
3) The code reader combines the bar code information of the part and automatically subcontracts;
4) Up to 3 packs of cloth can be cached.
2. Equipment components:
| Serial No |
Name |
Form |
Description of use |
| 1 |
Transmission module |
Receiving conveyor belt |
The cutting and receiving station of the dryer has built-in sensors to dynamically detect the cutting position |
| Buffer conveyor belt |
Collect the cloth and stack it neatly |
| Pressing tooling |
Remove the cloth gap and increase the stacking layers |
| 2 |
Code reader |
High speed code reader |
Used for dynamic identification of cloth cutting information for subcontracting judgment |
| 3 |
Electrical control system |
PLC touch screen sensor |
System action control |
| 4 |
Mechanism |
Other mechanism components |
- |
3. Equipment operation description:
1) The splice conveyor belt is responsible for slicing at the end of the dryer, and the built-in sensor detects the edge of the fabric part, and the feedback equipment collects the cloth.
2) The buffer conveyor belt flatly transplants the fabric, and stacks the fabric to the height specified by the user, and the receiving buffer is designed for a total of 3 stations, with a total length of 4.5 meters.
3) The number of palletizing layers cooperates with the material barcode information recognized by the front-end camera, and the fabric is sub-wrapped and layered with the appearance of the two-dimensional code as the principle of palletizing and division.
4. Equipment technology and environmental requirements:
1) The equipment layout is reasonable, the wiring is scientific and beautiful, in line with ergonomics, sharp corners, sharp angles are not allowed, and the position of human contact should be properly protected.
2) Equipment electrical and environmental requirements
| Ambient temperature |
-25-60ºC |
| Relative humidity |
20-80% non-condensing |
| Flammable gas |
None |
| Corrosive gas |
None |
| Compressed air source |
0.4-0.6MPa,flow rate not less than 400L/min |
| Supply voltage |
Single-Phase AC 220V±10% 50Hz |
3) The incoming parts are required to be flat, the spacing is fixed without lap, and the size range of parts that can be received:
| Cutting length range:(25-75)cm |
|
| Cutting width range:(10-85)cm |
| Stacking height:<25cm(the lower edge of the drying line is not less than 0.72 from the ground) |
5. Safety requirements:
1) The device is set with emergency stop function;
2) The electric control cabinet has electrical warnings and labels, and the electric control cabinet must have good grounding and a public grounding end;
3) All wiring must be firm and not loose, and there is a consistent identification line number corresponding to the electrical drawings; The wiring in the electrical cabinet must be neatly arranged in the online slot.
){kind=link}
){kind=link}